Gallery5

N2 Takes shape......

For Series four, Vikki, Michelle and I decided to build a whole new Napalm.

For reasons that will becoe obvious soon, we had seven weeks to design, build and test this new machine.

What follows are a few snaps of the machine as it evolved!!!!!

	Drive section competed as a solid LUMP!! The stainless steel support was positioned.
	The titanium is then cut into the correct sizes and checked against the body before rivetting to the steel.
	Drilling and rivetting Stainless and Titanium by hand for 20 rivets to line up is not a task thay I would recomend to anyone!
	One sheet in place, time for its partner.
	Front panels in place allow for the side armour to be developed.
	All dunded, and the legend emblazened on the rear.
	N2 completed. Note the N2 legend has yet to be created. We were not convinced that our first attempt was any good so we over sprayed.